It could use some improvement - the board isn't well supported so dropping the pedal could break the tube. Here's the layout file if you want to play with it. Poor planning, needs more work, but since the build runs I just jammed in a box up-side-down instead. The original plan was to board-mount the level and gain pots with the tube facing down and the DC jack above it, but I tried and it didn't fit. The top-side has 3 jumpers, plus one on the daughter board. That is to say, a double-sided board isn't necessary, it's just for mechanical strength. I made a double-sided board so I could effectively solder wires and the daughter-board underneath, but of course there are no vias, so they still needed to be soldered to the underside. I wanted to see if I could squeeze it in to a 125B, so I made a layout using ExpressPCB Plus and etched the board. Well, if you don't mind a 1590BB there's this. "Understanding How Transistors Work" - Stompbox Studies "Everything You Need to Build a DIY Guitar Pedal" - Pedal Haven "So you’re starting out - A guide to what you’ll need to build pedals." This is an open community for the do-it-yourself pedal builders of reddit! Please use this subreddit to share knowledge, give/receive help, and show off your custom builds! Looking for troubleshooting help? Please read this first!
0 Comments
Leave a Reply. |